Heatilator • HEIR36, HEIR42, HEIR50 Installation Manual • 2285-980 Rev. G • 12/14
46
D. Decorative Front Dimensions for Finish-
ing
A decorative front is required for this appliance. Only dec-
orative fronts certi
fi
ed for use with this appliance model
may be used. Contact your dealer for a list of decorative
fronts that may be used. Once you have determined what
kind of decorative front and
fi
nishing material is going to
be used on the
fi
replace, you may use the table below
which shows the decorative front models and the
fi
nish-
ing material thickness allowed. For an inside
fi
t there is an
available template to ensure that proper decorative front
clearances are maintained with
fi
nishing material with
thickness greater than 1 inch.
A
B
COMBUSTIBLE MATERIAL
C (ARCH)
Figure 10.13 Inside Fit Decorative Fronts
The decorative fronts approved for use with this appli-
ance have been designed to be installed by two methods:
Overlap Fit or Inside Fit. Before beginning the installation,
it is important to determine with method will be used.
Overlap Fit Method:
These decorative fronts have been
designed to be installed over
fi
nishing material up to one
inch thick.
Inside Fit Method:
These decorative fronts may be re-
cessed into non-combustible
fi
nishing material up to 6
inches thick.
NOTICE:
Proper clearances from the
fi
replace opening
to any
fi
nishing material thicker than 1 inch MUST be
maintained.
NOTE:
Finishing templates are included with this product.
See Section 10.B.
Table 10.1. Approved Decorative Fronts
DIMENSIONS
A
3/4 IN.
B
1-1/4 IN.
C
1-1/4 IN.
FIRESCREEN DECORATIVE FRONTS
RECTANGULAR
ARCHED*
FS-36
FS-36A*
FS-42
FS-42A*
FS-50
FS-50A*
*Requires Arch Template Kit (not included)
