53
Heat & Glo • HE36CLX-S • 2183-900 Rev. H • 1/14
J. Install the Log Assembly
LOG PLACEMENT INSTRUCTIONS
Log Set Assembly: LOGS-6000CLX
Models: 6000CLX-IPI-S, 6000CLX-IPILP-S 6000CLX-IPI-T,
6000CLX-IPILP-T, HE36CLX-S, HE36CLXLP-S
Figure 4
Figure 5
GROOVES
GROOVES
Figure 6
1
1
GROOVES
GROOVES
CAUTION:
Logs are fragile, handle with care.
Log #1 (2166-721)
: Locate log placement tabs on the pilot cover. Bend
tabs upward as shown in Figure 3. Tabs should be in a vertical orientation. A pliers may need to be used. Locate the log
placements slots on the bottom of Log # 1. See Figure 4. Mate the slots located on the bottom of Log #1 with the placement
log tabs on the pilot cover. Log # 1 is properly installed when it sits squarely and completely on pilot cover with tabs engaged.
See Figure 5.
Figure 1. 6000CLX
LOG PLACEMENT TABS
LOG PLACEMENT TABS
LOG PLACEMENT SLOTS
LOG PLACEMENT SLOTS
LOG PLACEMENT PROTRUSIONS
LOG PLACEMENT PROTRUSIONS
Log #2 (2166-722)
: Mate the groove located on the bottom of Log #2 with the left protrusion on top of Log #1. After groove
and protrusion have been
fi
tted together, mate the groove located on the bottom of Log #2 with the horizontal grate bar and
slide Log # 2 toward the left until it rests against the far left grate tine. See Figure 7.
Figure 5 shows the log placement protrusions located on the top of Log # 1. The protrusions will be mated with the grooves
located on the bottom of Log #2 and Log #3. See Figure 6. Log #2 and Log #3 also have grooves that allow the logs to be
seated properly on the grate. See Figure 6. Hold Log #1 upright while placing Log #2.
LOG PLACEMENT INDENTATIONS
LOG PLACEMENT INDENTATIONS
GRATE TINE
GRATE TINE
33
22
Bottom view of
Bottom view of
Logs # 2 and 3
Logs # 2 and 3
Figure 3
GUIDE SLEEVES
FIBER BURNER TOP
TAB BENT IN = NG
TAB NOT BENT = LP
BURNER ASSEMBLY
PILOT COVER
LOCATING HOLES
BURNER SHIELD
Figure 2. HE36CLX-S
LOCATING HOLES
PILOT COVER
BURNER ASSEMBLY
BURNER SHIELD
GUIDE SLEEVES
FIBER BURNER TOP
