47
Heat & Glo • HE36CLX-S • 2183-900 Rev. H • 1/14
16
16
Appliance Setup
FIREBOX LATCHES
STOWED
SUPPORT WHEEL
NUTS
SUPPORT WHEEL
ASSEMBLY
DEPLOYED
SUPPORT WHEEL
Figure 16.1 Disengage Firebox from Outer Shell
D. Disengage Firebox from Outer Shell
In order to perform certain setup and maintenance tasks,
it will be necessary to partially separate the
fi
rebox from
the outer shell of the appliance. Use a Phillips screwdriver
to loosen the 1/4 turn fasteners on the two latches on the
lower front face of the appliance and pull the
fi
rebox out
carefully using both hands. See Figure 16.1.
CAUTION! Risk of injury!
Avoid pinch points by grasp-
ing only front and side of appliance door when pushing
back into place.
NOTICE!
Appliance is heavy. Slide out and in carefully to
avoid scratching
fl
oor or hearth.
E. Engage Support Wheels
This appliance is
fi
tted with linear motion slide mecha-
nisms to provide guidance and support of the appliance
as it is separated from the outer shell. These slide mech-
anisms will de
fl
ect under the weight of the
fi
rebox. This
de
fl
ection presents the possibility of the
fi
rebox contact-
ing
fl
ooring materials as it is transferred in and out of the
outer shell. The appliance is equipped with support wheel
assemblies to carry the load and to reduce the possibility
of damage to
fl
ooring.
There is one adjustable support wheel on both the left and
right sides of the
fi
rebox to help support the weight of the
fi
rebox when it is being pulled out. Pull appliance out ap-
proximately four inches to access the support wheels. To
utilize the support wheel, loosen the nuts and adjust the
wheel to the desired height. Use care when pulling appli-
ance out to avoid scratching the
fl
oor or hearth. Rest the
slide in the slot at the appropriate height and tighten the
nuts. If the
fi
rebox will be extended to a point where the
wheel does not touch the surface, an additional means of
support will be needed.
WARNING! Risk of injury!
Support
fi
rebox with support
wheels. Firebox may tip when pulled away from outer shell.
When
fi
nished with appliance maintenance task, push the
fi
rebox back to within four inches of closing, adjust the
support wheels to the original stowed position and secure
in place. Engage the 1/4 turn fasteners on the latches on
the lower front face of the appliance, to secure it within the
outer shell. Pull gently on the
fi
rebox to verify the
fi
rebox
is correctly secured and latched.
A. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi
rebox.
B. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside or behind the
fi
rebox.
C. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock!
Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
