059705–00 REV. B
|
23
11
INSTALLATION
2
Position the Display Module into the base and secure it in place using the middle 2 screws removed in the previous steps outlined
in the Mounting The Enclosure.
3
Continue with
NOTE
The battery is a coin lithium battery (CR2032—Heat Timer P/N 020012–00) that is used to maintain the control’s date and
time during power outages. The battery can maintain the clock for up to a total of 100 days.
NOTE
Do not replace the Enclosure Wiring Cover until all wiring is completed.
MOUNTING THE DISPLAY MODULE
1
Turn the Genesis Heat-Timer
®
display module (1) over to reveal the battery (2) on the back of the circuit board. Remove the plastic
tab to activate the battery. Ensure the battery is properly seated and has not dislodged when removing the plastic tab.
CAUTION
Do not remove the battery plastic tab unless you plan to keep the control continuously powered. If the control has no
power, the battery will lose its charge in 100 days.
2
1
