4-2 Assembly Steps
Control Wire Extension
Upper Motor Cover
Philips Screw
Running Belt
Frame
Philips Screw
Hex Screw
Washer
Spring Washer
Hex Screw
Spring Washer
Washer
Philips Screw
Philips Screw
Two people should finish the assembly steps.
(Caution!! Please follow exactly the assemly steps below to aviod injury.)
1.
First, loosen (10) philips screws which fix the motor cover on the frame (B), then remove the upper motor
cover. Pull out the control wire with the guiding thread attached in the right upright, and then feed thread
into the side hole of the right upright,
then slightly fix uprights (C,D) on the frame by screw (a).
Insert
Hex
screw(h), and then tighen
up
screw (a).
Finally, put back the motor cover and tighten with philips screw.
Note: 1.When assembling the Upright, one person should hold the Upright to prevent it from falling.
2.
Before installing the upper motor cover,
be sure that there are no tools or screws droped into the frame.
20
2009/10/26 Ver1.0+V2.0
