HCI RM26ICS RoomMate, Operation Manual

Page: 9 / 40

-------------------------------------------------------------------------------------------ICS OPERATIONS MANUAL
HealthCare Information, LLC 9
INSTALLATION
Before installing, carefully read the “Important Safeguards” section on pages 4 and 5. These mounting
instructions cover all HCI RoomMate TVs
Install this TV only on a mount that has been properly mounted according to the mount manufacturer’s
instructions.
1. Unpack the TV from its shipping box.
2. Attach the TV to the mount following the mount manufactures directions.
3. For basic operation, connect a coax signal cable to the RF input on the rear jack panel. Plug one
end of the supplied hospital grade cord into the AC input on the rear jack panel. Plug the other
end of the power cord into a standard 120VAC outlet.
4. Follow the following directions to set up your new ICS set.
BASIC CONNECTIONS
PC (to use TV as a monitor)
Use a male to male VGA cable to connect a computer VGA output to the PC VGA input on the back of the set. Make sure the
computer resolution is set equal to or lower than 1280 x 800. A 1/8” (3.5MM) jack is located next to the VGA input for PC
AUDIO input.
Pillow Speakers/Sip-puff device
A ¼” jack is provided on rear jack panel of the set to connect a pillow speaker or sip and puff device. See page 21 and 24.
USB Port
A USB port is provided on the rear jack panel for software updates and cloning.
RJ-12 Serial Port
An RJ-12 port is provided to allow third party devices to control the set. This port is also used for some software updates.
CABLE
A standard F connector is located on the rear jack panel of the set to connect a signal coax cable to.
Earphone/Headphone
A 1/8” (3.5MM) stereo earphone jack is located on the front lower right side of the set.