HCI RM26ICS RoomMate, Operation Manual

Page: 10 / 40

-------------------------------------------------------------------------------------------ICS OPERATIONS MANUAL
HealthCare Information, LLC 10
SETUP AND OPERATION
Installing the IR Remote Control Batteries
1. Turn the IR Remote over. Press down on the arrow and slide the battery cover off the bottom.
2. Install the two included AAA batteries. The polarity is indicated on the bottom of the battery
compartment. Make sure the batteries are installed correctly.
3. Slide the battery cover back onto the remote and snap into place.
Function Codes
Setup features are accessed using function codes. You will need an IR remote control to enter function codes. To enter a function
code using an IR remote control, press the “FUNCTION” button followed by the “0” button. Set will display “ENTER
PASSWORD” then enter the function code. The following codes are available.
CODE FUNCTION
9999 ACCESS TV OR DVD SETUP MENU
10086 TURN TV ON DURING OFF HOURS
11111 DISPLAY SOFTWARE VERSION
13218 SHOW/HIDE DATE
14568 TEST MODE
15311 SET IR BAND TO BED ONE
15322 SET IR BAND TO BED TWO
15709 RESET
15428 SERVICE MODE
Note: If you change the IR band, your IR remote will no longer function until it is set to the same IR band as the TV. To
change the IR band of the remote, point the IR remote at the TV and press and hold the power button until the set turns
off.
Press the setup button on the IR remote after entering the “9999” code to access the TV / DVD setup menu.
Enter function code “15428” to keep the setup menu active until the TV is turned off. You can also set the OSD Time to always
to keep the menu active. See page 19. Once this code is entered you will not have to enter the “9999” code until the set is turned
off. Only one button analog or digital pillow speakers set for Zenith or Philips codes may be used.
NOTE: To select menu items press the “ENTER” button. Use the up/down arrow buttons to change menu section. Use the
left/right arrow buttons to change selected menu item.
Auto Scan
Access the setup menu. Select the “CHANNEL” menu. Select “Signal Type”. Set to “Air” if signal source is from an off air
antenna. Set to “Cable” if signal source is from a cable system. Select “Auto Channel Search”. Press the “ENTER” button. Set
will scan all for all analog/digital channels and add active channel to the channel list.
Setting Date and Time
Certain features such as the “ALARM” require the proper date and time to function properly. To set the date and time:
1. Access the “Setup Menu”. Select “SETUP”, “POWER ON SETTING”, “TIMER” then “Clock Setting”
2. Set “Time Zone” to match the time zone you are in.
3. Select “Daylight Saving Time”. Set to “On” if your area uses daylight savings time. Set to “Off” if your area does not
use daylight savings time. NOTE: Time is set in 24 hour format and displayed in 12 hour format.
4. Select “Setup Time” and press the “ENTER” button. Use the left/right, up/down or number buttons to set time. Press
the “ENTER” button when finished.
5. Select “Setup Date” and press the “ENTER” button. Use the left/right, up/down or number buttons to set time. Press the
“ENTER” button when finished. NOTE: The last digit is the day of the week. Monday is day one.