9
10
Setting Up the Controller
Setting Up the Controller
Havahart
®
Radial-Shape 2 Wireless Dog Fence
www.HavahartWireless.com
Havahart
®
Radial-Shape 2 Wireless Dog Fence
1-800-800-1819, Option 1
To attach using the removable wall-mount adhesive strips:
•
Once the Controller location is determined, gently clean the
wall surface with isopropyl rubbing alcohol, wipe gently and
let dry. DO NOT USE household cleaners (see Figure 1.0).
•
Separate strips (if still connected) at the perforation.
•
Peel the liner from the back of one of the strips and attach it
vertically to the middle of the Controller with the release-tab
pointed upward toward the antennas (see Figure 1.1a).
•
Connect another strip to the strip on the Controller by
pressing the fasteners of both strips firmly together until
they snap. The release-tab on the other strip should point
downward away from the antennas - the opposite direction
of the release-tab of the strip on the Controller (see Figure 1.1b).
•
Peel the liner from the back of the other strip and attach it
to the wall with the release-tab facing downward toward the
floor and the Controller antennas facing upward toward the
ceiling (see Figure 1.2).
To remove the adhesive strips:
•
Pull the Controller gently from the wall by disconnecting
the fasteners. DO NOT pull the strips off the Controller or
the wall.
•
Start with the strip on the wall. Press one hand on the top of
the strip. Use your other hand to pull the release-tab slowly
down against the wall stretching it at least 12 inches until
the strip releases. Repeat for the strip attached to the
Controller (see Figures 1.3a & 1.3b).
Installing the Radial-Shape 2 Wireless Dog Fence
Figure 1.0
Figure 1.1a
Figure 1.2
Figure 1.3a
NOTE: The removable wall-mount adhesive strips are not
recommended for wallpaper. Apply to surfaces above 50
˚
F .
Adhesive could soften and lose adhesion above 105
˚
F.
Figure 1.1b
Figure 1.3b
Installing the Radial-Shape 2 Wireless Dog Fence
Fence R
adius
1
Setting Up the Controller
Installing & Activating the Controller:
1.
Position the Controller inside your home on an outer wall
nearest the center of your desired containment area. Make sure a
standard 120V AC power outlet is nearby.
2.
Using the removable wall-mount adhesive strips (see Page 9)
or screw & wall anchor, mount the Controller on the appropriate
wall, approximately 6 feet off the ground or at eye level
(see Illustration A).
3.
Plug the Controller into a nearby standard electrical outlet.
4.
Press “Enter”
NOTE: It is recommended to use the removable wall
mount adhesive strips in the event that you later
determine the Controller is not in the correct place and it
needs to be relocated. If the strips will not work on the
wall of your choice and you want to get a rough idea of
where the Fence Boundary/Trigger Zone will exist before
you attach the Controller to the wall, find a way to keep
the Controller propped upright and as close to the desired
final position as possible.
Position the Controller at least 3 feet
away from large metal objects and major
appliances as these items may reduce the
size and shape of your Roaming Area (see
Factors Affecting Signal Strength on
Page 8).
!
IMPORTANT MESSAGE
Illustration A
NOTE: When the unit is first activated, you may receive a
“POWER FAILURE DETECTED!!!” warning. Disregard this
message and Press ENTER.
8
