Haulotte Group HTL 3210, Operator'S Manual

Page: 210 / 248

210 2420344510 E 11.11 AUS
Telescopic handlers
H
- Lubrication and maintenance
14.3 - INTERNAL COMBUSTION ENGINE
• Drain the motor oil :
Capacity : 7 l(1,8 gal US) with filters.
• Drainage is performed when hot.
• Loosen the drain plug and let the oil drain completely. Remove the oil filling cap.
• Clean the drain plug and refit it, taking care to change the seal.
• Fill until the oil reaches the MAXI gauge mark.
• Replace the filling cap and let the engine run at idle speed for a few minutes.
• Stop the engine and check the level. Top up the oil if necessary.
• Change the oil filter cartridge :
• Loosen and remove the filter cartridge.
• Oil the seal on the new cartridge, insert it into place on the engine carrier. Screw on the cartridge until
the seal contacts the sealing face.
• Tighten the cartridge by screwing it a further half-turn.
• Start the engine and check for sealing.
• Stop the engine and check the oil level. Top up the oil if necessary.
N.B. -:-Perform the first drainage and the first oil filter cartridge change after the first 500 hours of
operation.
For the following operations, park the machine on a horizontal surface and turn off the engine.