142
2420344510 E
11.11
AUS
Telescopic handlers
F
- Emergency procedure
1.2 -
RELEASING THE AXLE BRAKE FOR TOWING
on HTL4010 and HTL3210 only :
The following procedure is used to release the front axle parking brake in the event of a engine
breakdown or when the accumulator is empty.
1.2.1 - Parking brake deactivation
on HTL4010 and HTL3210 only :
Tools required :
• Allen 8 mm wrench.
• Reversible 3/8'' ratchet and 3'' extension.
• Park the Telehandler.
• Block the four wheels again.
• The machine can be towed (
Section F 1.1 - Towing a broken-down vehicle).
To access brake release screws ( 1-2-3 ) (see figure
below), you must loosen the 6 cap screws ( 3 on each
side) positioned around the flanges on the (rigid) front
axle. (See photo opposite).
Block the four wheels with chocks to prevent any machine movement when the brake is disengaged.
• The Allen 8 mm key should be used to disengage the
parking brake correctly.
• Draw a mark so that you can count the number of
revolutions made by each nut in order to make the correct
adjustment upon reassembly.
• Locate the six brake release bolts ( 3 on each side) under
the front axle.
• Tighten bolts ( 1-2-3 ) alternatively in half turns clockwise
until you feel resistance (approximately 5,5 turns).
• Note the number of turns made for each screw.
Come out from under the Telehandler and remove the chocks placed under the four wheels.
Summary of Contents for HTL 3210
