Place the steel track and drive centrally on the garage floor with the cardboard underneath. Lift the
front of the guide up to the door support. Insert the pivot pin and secure it with the supplied split pin.
STEP 3 (Fig. 3, Fig.4)
Raise and support the motor head (ladder) so that it is centered and level. Secure the drive to the
ceiling with the perforated brackets.
WARNING:
Do not allow children to play at the door, drive, or access ladder as this may cause injury
or damage.
STEP 4 (Fig. 3, Fig.5)
Connect the straight arm to the bent arm with a screw.
Position and screw the arms to the top edge of the door with
supplied screws.
Fig. 4
STEP 5
Raise the garage door until the mechanism engages.
The DRIVE is now ready to be programmed.
Fig. 5
Installation of divided guides (option)
Fig. 6
Fig. 7
1.
2-part rail:
As shown in Fig. 6, slide the A rail into the coupler, slide the B rail into the coupler.
3-part rail:
As in fig. 7, insert the C rail into the coupler, slide the D rail into the coupler; slide the E rail into the coupler.
7
Rail divided into three
Rail divided into two
A
:1500 mm
B
:1500 mm
C
:1000 mm
D
:1000 mm
E
:1000 mm
coupler
coupler
coupler
Summary of Contents for 300 SILENT 1000N
Page 28: ...DISTRIBUTOR 28...
