8. ADJUSTING THE HEIGHT OF THE PARTIAL OPENING OF THE GATE
a) Press and hold the
SET
button until the display shows "1", then press the
UP button until the display shows "8",
b) Press the
SET
button again. The device is now in the partial opening /
height adjustment mode. The display will show the digit "0" and a flashing
dot.
c) Press
UP / DOWN
button once to select whether you want to open the
partial opening function or set the partially open height. (0 ~ 9). Press the
UP
button to increase or
DOWN
button to decrease.
The digit "0" means the closing of the partial opening function.
The number "1 ~ 9" means full height setting to partially open position.
One-tenth of nine-tenths of the total height, etc ...
d) Press the
SET
button to confirm the set, then it will return to standby
automatically and display "ll".
ATTENTION!
1. Partial opening / height is factory-set to "0".
2. If you enable the partial opening / height function, the button
recognition function will be disabled.
3. If you enabled the partial opening function and then disabled this
function later, note that only the coded button you set at the beginning
can now control the drive.
4. Partial opening is performed by button 2 on the remote control
7. GATE RETURN HEIGHT SETTINGS
a) Press and hold the
SET
button until the display shows "1", then press
the UP button until the display shows "7",
b) Press the
SET
button again. The device is now in the gate return height
adjustment mode. The display will show the digit "0" and a flashing dot.
c) Press
UP / DOWN
button once to set the gate return height during
closing (0 ~ 9) when obstacle is encountered.
d) Press the
UP
button to increase or
DOWN
button to decrease.
The digit "0" means that the door will return to the end position
OPEN. Digit "1 ~ 9" means the door will return to the gate opening
percentage height. One-tenth of the entire height, etc ...
e) Press the
SET
button to confirm the settings, the drive will
automatically go back to standby state and display "ll".
ATTENTION! The return height is by default set to "0".
16
Summary of Contents for 300 SILENT 1000N
Page 28: ...DISTRIBUTOR 28...
