HATO 300 SILENT 1000N, Operating Manual

Page: 26 / 29

power board
4. Check that the power cord is connected
5. Check whether the low voltage side of transformer is 26V AC, if there
is 26V AC, replace PCB. If not, replace transformer
While programming
the display shows
The route is set at less than 30 cm or more than
9 m
Re-set the end positions
Display shows
Drive is not running or has stopped
running
Too low voltage Check the power supply
Display shows
LED lamp will blink 10 times quickly
The garage kit is in poor condition The garage door and motor require maintenance
Display shows The drive cannot lock up Replace drive
Drive is not working
The display shows
Error while setting the end positions
Incorrect setting of the end positions
Re-program the UP / DOWN limit setting as instructed
The LED is on all the time The control panel is damaged or the power
board is damaged.
Replace the control panel or power board
When you try to open the gate remotely,
The drive automatically stops after
passing 10cm
The display shows
The sensor cable or the engine speed sensor
itself is defective.
.
Open the casing and check: sensor cable reconnect it or replace the
sensor.
Drive is not working
You hear a ‘kaka’ sound from the relay
The display shows
The cable between the gear motor and the
plate is broken
Open the hood and check the connection between the motor and the
board.
The drive stops automatically after
driving 10 cm
The display shows
The cable between the motor and the board is
connected backwards
First, disconnect the power, open the cover and swap the wires
between the motor and the board. Re-set the end positions.
The door opens but does not close and
the display shows
The photocells function has been activated but
no photocells have been connected.
1. Disable the photocells function if they are not connected (see
manual)
2. Check that the photocells are properly connected or that there is no
obstacle in the light of their operation.
The drive is fully open and closes after a
few seconds
The LED lamp blinks 4 times
The automatic closing function is enabled Set the shutdown time or disable the function
(See manual)
The garage door stops and the LED light
is on all the time
The power board is damaged Replace the power board
26