11
PROGRAMMING
1.
ADJUSTMENT OF THE END POSITIONS
a) Press and hold
SET
button to enter the function, the display shows "1", then
release the button
b) Briefly press the
SET
button. The door drive is now in
end position programming mode. Then "n" will appear with a dot flashing on the
screen
c) Press and hold the
UP
button until the door reaches the open position you want,
you will see "n" no dot on the display
d) Press the
SET
button to confirm the open item, then you will see "u" with a dot on
the display
e) Then press and hold the
DOWN
button until the door reaches your desired closed
position, you will see a "u" without a dot in the display
NOTE:
For precise settings, the
UP
and
DOWN
buttons can be toggled
f) Press the
SET
button to confirm the closed position, then you will see “II” with a dot
on the display
After confirming the closed position, the actuator will perform a full cycle of opening
and closing in order to check the opening and closing limit and the operating force of
the actuator.
After these steps, the garage door is ready for operation.
ATTENTION!
After the opening and closing cycle, the display will show numbers (0 ~
9), "0" means the door is balanced, the smaller number means the door is better
balanced, strongly recommended that the number is less than the drive force.
ATTENTION!
Do not force the door in any end position. Such setting of the end position may
result in the lack of reaction of the drive.
Summary of Contents for 300 SILENT 1000N
Page 28: ...DISTRIBUTOR 28...
