
Page
9
of
34
Harvest
by Meridian
H10XX
Assembly
Manual
Step 12
Next, locate the gearbox mounted inside of the infeed housing. Remove the 2 top plugs in the gearbox &
replace the top one with the grease zerk & the bottom one with the breather provided.
Step 13
Next, slide the 4 botl 1-1/4” cast flange bearing over the shaft making sure the grease zerk is located on the
same side as the idler sprocket. (If the shaft has surface rust, clean first with an emry cloth) Secure the 4 bolt
bearing to the infeed housing using (4) 1/2" x 1-1/2” carriage bolts & flange nuts as shown. When completed
use a punch to rotate the shaft so the keyway is in an easy to access position.
Fig. 12.1
Fig. 13.1