![background image](http://html1.mh-extra.com/html/harvest-tec/720-dew-simulator/720-dew-simulator_owners-manual_2103728023.webp)
23
Operating
Once the system has been heated up, you can proceed to treating windrows. With the PTO still running, you
can lower the reel to the operating position and pull into the windrow running at the ‘desired mph’ to match the
baler’s speed. The arm switch will control the open/close of the 2 way valve. When the reel is in the operating
position, the heaters will turn back on and modulate their heat output as needed to achieve a stable output
temperature very close to the target temperature. The heaters will do this by cycling on and off as needed. This
can be observed by watching the indicator lights for heater 1 and heater 2 on the back of the heaters.
While operating, ensure that the gauge pressure that you set remains close to the Set Pressure value
(calculated by the control). You can also observe your target vs actual GPM on the lower right side of the main
screen of the controller. Pressure and Actual GPM’s may be able to be adjusted by throttling up or down.
**Do not exceed 1000 rpm on the PTO or 1200 PSI on the pump pressure.
Control Box
Screen Definition (Control)
Setup Screen
Harness
Connection
Operation
Screen
Mounting
Bracket
On / Off
Button
Summary of Contents for 720 Dew Simulator
Page 2: ...2 intentionally blank...
Page 7: ...7 Safety Decal Locations...
Page 69: ...69 Notes...
Page 70: ...70 Notes...