![background image](http://html1.mh-extra.com/html/harvest-tec/720-dew-simulator/720-dew-simulator_owners-manual_2103728025.webp)
25
Diagnostic Screen:
T_in
:
Temperature at the inlet to Heater #1
T_out
:
Temperature at the outlet of Heater #2
Prev T_out:
Temperature measured at T_out 5 seconds prior
GPM:
Gallons per minute
Req’d BTU’s:
BTU’s required based on the inputted variables to obtain target Temp
Actual BTU’s:
BTU’s currently being produced
Heater #1 Hrs:
Number of hours that heater #1 has been firing, not overall machine hours
Heater #2 Hrs:
Number of hours that heater #1 has been firing, not overall machine hours
H1 & H2 Lights:
Indicate when heaters are firing
Software Version:
Indicates version of software and language
Main Screen:
Tab Descriptions
1. Heater #1: Used to turn on the heater located on the left of the Dew Simulator (closest to diesel tank).
o
PTO must be running, flow meter must have reading, flow switch must sense flow, and arm switch
or arm override must be active for heater to turn ON
2. Heater #2: Used to turn on the heater located on the right of the Dew Simulator (farthest from diesel tank).
o
PTO must be running, flow meter must have reading, flow switch must sense flow, and arm switch
or arm override must be active for heater to turn ON
3. Target Temp: Displays the temperature you have selected as the desired temp to output (220F-260F).
4. Output Temp: Displays the temperature of the water being applied.
5. Operating Temp Status: Will display the status of the water heat Low, Ok, or High (<205=Low, 205-
270=OK, >270= High).
6. Target PSI: Displays the Target PSI determined from SETUP screen inputs (300-1200 PSI).
Summary of Contents for 720 Dew Simulator
Page 2: ...2 intentionally blank...
Page 7: ...7 Safety Decal Locations...
Page 69: ...69 Notes...
Page 70: ...70 Notes...