5. With the ON/OFF Switch in the Off position (‘O’), plug the Cord into
a 120 volt wall outlet.
6. Rotate the Speed Control to the lowest setting. Then flip the
ON/OFF Switch to the On position (‘I’) and slowly increase the
speed to maximum. Run at this speed for 30 – 60 seconds.
7.
Switch to the Off position (‘O’) and unplug the Blender Base from
the wall outlet.
8. Remove the Jar from the Base, empty and rinse the Jar with clear
water to remove all soap from Jar.
9. Wipe the Blender Base with a damp cloth. If necessary, you can use
a little mild detergent on the cloth.
DO NOT immerse Blender Base in water or any other liquid.
10. Clean the Tamper, Lid and Cap with warm soapy water.
11. Air or towel dry with a soft towel. Then place onto Blender Base
ready for next use.
WARNING:
Use extreme caution when handling the Jar, the Blades
are very sharp.
Blender Base
1.
Unplug from the wall outlet. Wipe exterior housing with a soft
damp soapy cloth.
NEVER allow any liquid to enter the interior of the Blender Base.
NEVER use stiff brushes or abrasive cleaners or pads to clean the
Blender Base as this will scratch or dull the surface.
2. Lift the Centering Platform off the Blender Base and wash the
Platform in warm soapy water. Rinse and Dry.
3. Should the Switches or Speed Control become sticky, clean with a
cotton swab dampened with a mild liquid detergent.
Dry
immediately.
Periodic Jar Sanitizing
1.
To sanitize, fill the Jar with hot water.
2. Add 1 tablespoon (15 ml) of liquid chlorine bleach.
3.
DO NOT turn Blender on.
Use spoon to gently and carefully stir for
10 seconds. Let mixture stand in Jar for ten minutes.
4. Empty water/bleach mixture. Without rinsing, set Jar aside to air
dry. Then place onto Blender Base ready for next use.
NOTE:
The Jar is dishwasher safe on the top rack ONLY. However, to
prolong the life of the Blender parts we recommend you hand wash the
Jar, Lid, Cap and Tamper by hand as described above.
TROUBLESHOOTING
Blender does not operate (no power)
1.
Ensure the cord is plugged into a grounded 120V outlet. Check the
circuit breaker or fuse.
8
