10.
Pulse Switch
– With the Jar/Lid properly installed, press down
on this Switch to operate the Blender momentarily at the highest
speed. The Blender will run at this speed as long as the Pulse Switch
is held down. The Pulse function can be used when the ON/OFF
Switch is in either the ‘I’ or ‘O’ position. The Blender will return to its
previous speed or stop when the Pulse Switch is released.
11.
Variable Speed Control
– Control the rotational speed of the Blades
by turning the Speed Control, clockwise to increase and counter
clockwise to decrease.
12.
Power Cord
– Grounded (3 prong) 120 volt cord
13.
Feet
– 4 rubber anti-slip feet
14.
Tamper
– Designed specifically for this Blender, the Tamper will help
to safely move blocked ingredients without contacting the Blades.
It is intended to be used only when the Lid is in position and food
stops circulating in the Jar. Remove the Cap and Insert the Tamper
up to the stopper. Hold the Jar handle with one hand and with the
other move the Tamper in both a circular and up/down motion to
unblock the contents of the Jar.
15.
Cord Wrap Retainer
- flexible Cord Wrap Retainers hold the excess
power cord in position. Unwind the Power Cord to the desired
length leaving the unused portion stored
under the Blender Base.
16.
Overload Reset Button
– To protect the motor of your Blender from
overheating during exceptional situations, the Blender will automati-
cally shut off. If this happens return the ON/OFF Switch to Off ‘O’
position, remove the Jar and wait for the motor to cool. After
approximately 5 - 20 minutes the Blender will reset automatically. If
not, press this Button
under the Blender Base.
4
1
2
12
16
6
5
9
11
4
7
10
8
15
13
3
14
