2. Unplug the Base, remove the Jar and press the Overload Reset
Button under the Base.
My Blender stops while blending
1.
Your Blender is equipped with an overload protector that will
prevent it from overheating during exceptional situations such as
when blending thick contents for extended periods of time. To
protect the motor the Blender will automatically shut off. If this
happens return the ON/OFF Switch to Off position (‘O’), remove
the Jar and wait for the motor to cool. After approximately 5 - 20
minutes the Blender will reset automatically. If not, press this
Overload Reset Button under the Blender Base.
2. Check consistency and volume of contents and reduce as required.
3. To prevent overheating:
•
Ensure that nothing is blocking the air vents under Blender Base.
•
Follow tested recipes.
•
Do not run Blender for longer than necessary.
•
Use the Tamper to ease blending of thick mixtures.
Results are uneven
1.
Reduce the amount of ingredients.
2. Ensure that all ingredients are about the same size.
Results are too watery or fine
1.
Use the Pulse function to prevent over processing.
Liquid is spilling out of the Jar
1.
Reduce volume of ingredients in the Jar.
2. Ensure that the Lid and Cap are securely in place.
Unusual Noise or Vibration
1.
Ensure the Blender is on a clean, flat, dry and level surface.
2. Switch to Off position (‘O’), wait for Blades to stop rotating and
unplug Cord. Check that the Jar has been properly seated on the
Centering Platform and that no undesired object is in the Jar.
3.
NEVER move, rock or remove the Jar while the Blades are turning.
This will damage your Blender.
4. Ensure that the Jar is not overloaded.
5. The noise level will vary during blending depending on the size,
hardness and type of ingredient(s) being processed. The sound will
change during the blending cycle as contents are chopped and the
mixture is blended.
6. Check to ensure that the Locking Nut is tight (see below).
Locking Nut is loose
1.
Should the Locking Nut under the Jar become loose, STOP using
the Jar immediately.
2. Contact the SALTON service department (see Warranty section).
9
