1
2
3
4
0.25mm
FRONT WHEEL
REMOVAL
Support the motorcycle with a jack or wooden
block.
Remove the bolt for the flexible cable of
odometer and disconnect it.
Remove the adjustment nut
, brake cable
and brake arm pin
of the front brake.
①
②
③
Remove the wheel axle nut, hub and front
wheel, remove the bush from the right side.
Remove the brake drum cover
from the left.
④
Place the wheel axle on a V-shaped block and
measure the radial run-out.
Actual run-out should be 1/2 of the reading.
Service limit
Rotate the inner ring of each bearing with
fingers; the rotation must be smooth without
abnormal noise.
Check if the outer ring of the bearing fits tightly
with the wheel hub. If the rotation is not
smooth or it fits too loosely with the hub,
replace with new bearings.
Note:
Replace the bearing in pairs.
INSPECTION
●
●
●
●
●
●
●
●
●
CHASSIS
5 - 4
https://www.motomanuals.net/
