(38)
Haojue HJ100T-7C 99011H79030H000 V01 Export Chinese 2016-6-30
The mark
extending line is in
the allowed range
Wear limit of rear brake
There is a wear limit mark on
the rear brake of the motorcycle.
Inspect the wear situation of the
rear brake following the essentials
below.
1. Inspect
whether the braking
system
has
been
properly
adjusted.
2. Operate the braking system and inspect and make
sure the mark extending line
1
is in the allowed range
3
(see the figure) marked on the wear limit mark
2
, otherwise have the component in the rear brake
replaced by a qualified distribution and maintenance
organization for safety.
TIRES
Periodic checks should be performed for tire pressure
and tire wear status.
To ensure maximum safety and
life, check the tire frequently, in addition to the scheduled
inspections.
B
WARNING
Tire pressure and wear status are very important
for the performance and safety of the motorcycle.
Be sure to check tire pressure and tire wear status
regularly.
Tire pressure
Under normal temperature, test the tire pressure by using
a tire pressure gauge, set the pressure base on the
pressure value recommended by this manual.
If the
pressure is too high or too low, it will affect ride stability,
and will cause the tire to wear.
Standard for tire pressure under normal temperature
Solo riding
Double riding
kPa
kgf/cm
2
kPa
kgf/cm
2
Front wheel
125
1.25
125
1.25
Rear wheel
200
2.00
250
2.50
B
WARNING
The tire pressures and surfaces are significant. If
they are neglected, the safety of the rider may be
endangered and the motorcycle may be damaged.
B
WARNING
Please inspect the internal pressures and surfaces
of the tires of the motorcycle frequently.
Tire surface status
There are serial “T.W.I.
;
” marks
1
(tire wear indicator) in the edge of
the tire. Check the bulge stock
2
of
T.W.I. in the tread near the mark. If
the tire wears off to reach the bulge
stock, the tire should be replaced.
(38)
Haojue HJ100T-7C 99011H79030H000 V01 Export Chinese 2016-6-30
37
