Haojue HJ100T-7C 99011H79030H000 V01 Export Chinese 2016-6-30
(33)
help of the main stand.
2. Remove the engine oil dipstick
1
.
3. Place a drain pan below the engine. Dismantle the
drain plug
2
and its washer to drain the original
engine oil.
4. After draining all the engine oil, install the drain plug
2
and its washer.
5. Fill 750 milliliter of new engine oil into the engine via
the oil filling port of the dipstick.
6. Install engine oil the dipstick again
1
.
7. Start the engine and have it run for several minutes.
8. Stop the engine and inspect the engine oil with
the dipstick several minutes later.
The engine oil
level should be between the UPPER LEVEL and the
LOWER LEVEL.
B
CAUTION
Use
the
engine
oil
recommended
in
the
“Instructions for use of fuel and engine oi”.
B
CAUTION
Carefully inspect whether the engine parts that
have been dismantled and installed again suffer
any oil leakage.
B
CAUTION
It is suggested to replace the seal rings when the
engine oil filter element is replaced.
Engine oil strainer
Regularly replace the engine oil strainer as instructed in
the “Table of Regular Maintenance”. The replacing steps
are as follows.
1. Completely drain the original engine oil as instructed
in section “Engine oil replacement”.
2. Dismantle the engine oil strainer cap
1
and take out
the spring
3
and the engine oil strainer
4
.
NOTE: Do not lose the seal ring
2
on the engine oil
strainer cap.
3. Clean and inspect the engine oil strainer and, if it is
damaged, replace it.
4. Install the spring, the engine oil strainer and the engine
oil strainer cap.
NOTE: Do not lose the seal ring
2
on the engine oil
strainer cap.
5. Add the specified new engine oil into the engine as
instructed in section “Engine oil replacement”.
32
Haojue HJ100T-7C 99011H79030H000 V01 Export Chinese 2016-6-30
(33)
