HanseLifter HIW-02 Series, Operating Instruction

Page: 36 / 427

Page 13 of 22
HIW / HTF-02 series any kind of reproduction, even in parts, is not permitted.
UK
Commissioning
Operation
Figure 5 Operating buttons
1 Emergency stop button:
Press the emergency stop button to interrupt the power
supply. The button locks in a recessed position. Turn it
in a clockwise direction to reactivate the electrical
circuit. The button springs back out from its recessed
position into the normal position.
2
Key switch
3 Lifting:
press and hold the button to carry out the lifting
operation. The lifting operation continues as long as the
"Lifting" button is pressed, or until the limit stop is
reached.
Lowering:
press and hold the "Lowering" button to carry out the
lowering operation. The lowering operation continues as
long as the "Lowering" button is pressed, or until the
limit stop is reached.
Key switch
Figure 6 Switch positions key switch
To switch on the equipment, turn the key switch in a
clockwise direction to the notch.
The equipment is ready for operation.
To switch off the equipment, turn the key switch in an
anti-clockwise direction to the "OFF" position.
Then pull out the key to secure the equipment against
unauthorised use.
Safety devices
The lift table will not carry out the lifting function if too much weight is placed on it, in order to avoid overload. If
this occurs, remove as much weight as necessary so that the maximum capacity is not exceeded.
Activation of the safety edge during the lowering operation leads to an immediate stop of the lowering operation.
It is not possible to lower the lift table any further. A short lifting operation must be carried out first to release the
safety lock.
The safety edge is located at the bottom edge of the tabletop. It is installed all around the edge to avoid the
danger of crushing.
Instruction
Do not carry out any modifications or manipulations of the safety devices.