HanseLifter HIW-02 Series, Operating Instruction

Page: 41 / 427

Page 18 of 22
HIW / HTF-02 series any kind of reproduction, even in parts, is not permitted.
UK
Warranty
Original parts and accessories
Only use original HanseLifter® parts for your HanseLifter lift table. The installation of spare parts and
accessories from other manufacturers is not tested and approved and can adversely affect the properties of the
equipment for this reason. Any liability of the manufacturer is excluded for damage caused by the installation of
non-original parts and accessories. In addition, the warranty is void if replacement parts or third-party
accessories are installed without authorisation.
Use only HanseLifter®
®
products.
Tightening torques
Tightening torque (Nm)
Dimension
4.6 5.6 6.6 8.8
M 6 4-5 5-7 6-8 9-12
M 8 10-12 12-15 14-18 22-29
M 10 20-25 25-31 29-39 44-58
M 12 35-44 44-54 49-64 76-107
M 14 54-69 69-88 83-98 121-162
M 16 88-108 108-137 127-157 189-252
M 18 118-147 147-186 176-216 260-347
M 20 167-206 206-265 245-314 369-492
M 22 225-284 284-343 343-431 502-669
M 24 294-370 370-441 441-539 638-850
M 27 441-519 539-686 637-784 933-1244
M 30 529 - 666 666 - 833 784 - 980 1267 - 1689
M 36 882 - 1078 1098 - 1372 1323 - 1677 2214 - 2952
Table 4 Tightening torques
Note:
•
Only use screws of strength class 8.8 for all load-bearing and other important parts.
The strength classes are listed in the table above