H&S GM 170, Operator'S Manual And Parts List

Page: 15 / 86

TRACTORS:
This operators manual uses the term “Tractor” when identifying the the power source.
W A R N I N G
TO PREVENT SERIOUS INJURY OR DEATH
Study The Above Safety Rules
ATTENTION - BE ALERT - YOUR SAFETY IS INVOLVED
BEFORE YOU ATTEMPT TO OPERATE THIS EQUIPMENT, READ AND STUDY THE FOLLOWING
INFORMATION. IN ADDITION, MAKE SURE THAT EVERY INDIVIDUAL WHO OPERATES OR WORKS
WITH THIS EQUIPMENT, WHETHER FAMILY MEMBER OR EMPLOYEE, IS FAMILIAR WITH THESE
SAFETY PRECAUTIONS.
H&S Mfg. Co. always takes the operator and their safety into consideration and guards exposed moving
parts for their protection. However, some areas cannot be guarded or shielded in order to assure proper
operation. In addition, the operators manual and decals on the machine itself warn you of further
danger and should be read and observed closely.
-13-
KNOW HOW TO STOP MACHINE BEFORE STARTING IT.
If the machine becomes clogged or for servicing, Stop the tractor engine, remove ignition key
and allow all mechanisms to stop. Before cleaning or working on the machine, detach the PTO
shaft, and completely disengage the tractor hydraulics.
DO NOT attempt to perform maintenance or repair with tractor running, PTO and hydraulic hoses
connected to the tractor.
DO NOT step up on machine at any time while in operation.
DO NOT allow minors to operate or be near the machine.
DO NOT ALLOW PERSONNEL OTHER THAN THE QUALIFIED OPERATOR NEAR THE
MACHINE.
STAY CLEAR of discharge auger when in operation.
Keep hands, feet, and clothing away from all moving parts when the Grinder-Mixer is in operation.
Loose or floppy clothing should not be worn by the operator.
Be sure the machine is clear of people, tools, and other objects before engaging PTO.
Do not step over PTO shaft: Stay clear of PTO at all times.
NEVER start the Grinder-Mixer until all guards and safety shields are secured in place.
Never operate Grinder-Mixer with a PTO speed greater than the recommended PTO RPM.
STAY CLEAR of hydraulic lines, they may be under extreme pressure or heat.
NEVER open or plug the water drain holes with the Mixer running.