H&S GM 170, Operator'S Manual And Parts List

Page: 34 / 86

LUBRICATION (cont.)
-32-
Telescoping PTO Drive (3 zerks)
Flywheel (1 zerk)
Front & Rear Mill Bearings
(2 zerks - remote in Grease
Bank under main shaft shield)
Main Shaft Slider Bearings
(2 zerks - remote in Grease
Bank under main shaft shield)
Transfer Auger Front Bearing &
Shear Hub (under mill cover, 1
zerk on front bearing, and 1 zerk
on transfer auger shear hub)
Transfer Auger Rear Bearing
(1 zerk - remote on
rear of frame)
Transmission Main Bearing
(1 zerk - remote on
rear of frame)
Top of Mixing Auger
(1 zerk - under top
of tank cover)
Unloading Auger Pivot/Collar
(4 zerks - 2 on the top of
the collar & 2 on the
bottom of the collar)
Unloading Auger-(1 zerk at the end
of the auger discharge spout)
Unloading Auger-(1 zerk on the
top of vertical section auger and 4
zerks on vertical auger pivot.)
SIA Upper Pivot Bearing
(1 zerk)
SIA Lower Pivot Bearing
(1 zerk)
Auger/Transmission Main
Shear Bolt-(1 zerk)
Oil level should be between
Max/Min level marks