Handicare MINIVATOR 2000, Installation Manual

Page: 9 / 52

Electrical connections
MINIVATOR 2000 INSTALLATION MANUAL 9
Track electrical connections
Items required: Tools required:
• Track drawing • 6mm Allen key
• Fitting kit • 3mm Allen key
• Track • 2.5mm Allen key
• Feet • 13mm Spanner
• Stanchions
1 Use the pull through that you fitted inside the
track to pull the red cable through the track
(Figure 14) .
2
Decide if the power supply will be installed at
the top or bottom of the staircase.
3 Remove the end caps from the bottom track
at the top and bottom of the stairs (Figure 15) .
4 Connect the positive charge contact to the
cable that you pulled through the track at
the top and bottom of the stairs using the
supplied terminal blocks.
Hinge track installations
Each stanchion next to a charge comms contact
should be drilled
(Figure 16) . For the first
occurrence of charge comms contacts you must:
a Connect the grey cable from the hinge
track to the grey cable that you have pulled
through the top track.
b Insulate this connection and push it through
the hole in the front of the track.
c Feed the grey cable from behind the
comms contact out of the track and into the
stanchion and out of the top of the stanchion.
d Connect the comms contact to the grey wire
in the top track using a connector block.
e Connect some more grey cable to this
connector block and feed it into the
stanchion and out of the top of the stanchion.
f Insulate the connector block behind the
comms contact and then push it into
the track.
g Connect the two grey cables that are
protruding from the top of the stanchion
with a connector block, insulate and then
push in to the top of the stanchion.
For every further intermediate comms contact:
a Pull the grey wire out of the bottom track
behind the charge contact.
b Splice a length of grey cable from this and
feed it in to the stanchion and out of the top
of the stanchion.
c Feed the grey wire from the comms contact
in to the stanchion and out of the top of the
stanchion.
d Connect the two grey cables that are
protruding from the top of the stanchion
with a connector block, insulate and then
push in to the top of the stanchion.
For the top comms contact:
a Pull the grey wire out of the bottom track
behind the charge contact.
b Feed the grey wire into the stanchion and
out of the top of the stanchion.
c Feed the grey wire from the comms contact
into the stanchion and out of the top of the
stanchion.
d Connect the two grey cables that are
protruding from the top of the stanchion
with a connector block, insulate and then
push in to the top of the stanchion.