Handicare MINIVATOR 2000, Installation Manual

Page: 18 / 52

18 MINIVATOR 2000 INSTALLATION MANUAL
Fitting the seat back
Arm Switched Powered Footplate Only
c Powered footplate:
Twin yellow to twin yellow
Note: The toggle switch connection must be
made through the interlock loom to enable the
arm interlock functionality
(Figure 43) .
3 Tidy the cables to the back of the seat
(Figure 44) .
Emergency Swivel Lever
1 Feed the anti-tamper seal through the
emergency swivel lever (Figure 45) .
2
Near the front flap of the seat there is a large
and a small hole. Pass the anti-tamper seal
through the small hole, then feed it back
through the larger hole and back on itself
through the hole in the end of the anti-tamper
seal. The lever should be attached on the
down side of the lift.
3 Pull the anti-tamper seal tight and trim off any
excess to leave the lever hanging securely.
Note: The user must be informed that the
lever is for emergency use only.
To use, the lever should be twisted to break the
anti-tamper seal. The lever can then be inserted
into the swivel lever socket. It must be held in
place to operate the swivel mechanism.
Figure 43
Figure 44
Figure 45