Handicare MINIVATOR 2000, Installation Manual

Page: 24 / 52

24 MINIVATOR 2000 INSTALLATION MANUAL
Fixing the track
Fix the track to the stairs
Items required: Tools required:
• Screws • 6mm Allen key
• No. 3 pozi-drive
1 Drive the power pack up and down the stairs
to ensure that it will not encounter any
unforeseen obstacles
(Figures 57 and 58) .
Note: Look for any other potential obstacles
such as window ledges or exposed pipework
that could obstruct the movement of the lift
at this stage. If there are any other obstacles
then move the track away from the wall until
the rear edge of the power pack can travel
freely past them.
2 Using the screws supplied locate the feet
using three screws per foot but do not fully
tighten the screws until the feet have been
adjusted to ensure vertical alignment of the
stanchions
(Figure 59) .
3
Vertically align the stanchions by screwing the
three adjusters on each foot up or down as
required
(Figure 60) .
Note: To align the track identify 1 key
stanchion per run. Align the rest of the track
to this stanchion. Start from the corner when
adjusting the front adjuster screws before
fixing to the stairs.
4 When all the stanchions are vertically aligned
tighten the screws fully to fasten the foot to
the floor or riser.
Figure 59
Figure 57 Figure 58