HQ Infinity User Manual
| 25
3. Tighten the nut using the 5mm hex wrench.
Slide the laser clamp onto the mounting post
and tighten the two knobs on opposite sides of
the clamp.
4. Plug the cable end into the laser stylus port
on the back of the machine. Wrap the excess
cable around the rear handlebars, or insert it
into the Handi Accessory Rail and use the
T-slot clip to secure.
The laser projects a straight laser beam visible as a dot on surfaces it hits. The laser dot is used as a guide
or stylus enabling you to use printed pantograph designs and stitch the continuous pattern onto a quilt by
tracing the design with the laser dot.
ONLINE
: For more information about quilting with pantographs, watch the video
Using Pantographs
at:
http://www.handiquilter.com/videos/hq-infinity/238/
.
The laser attaches to a mounting post which attaches to the accessory track along the right side of the
machine. The laser stylus can move in any direction by rotating the clamp on the post and pivoting the
laser up or down. To make an adjustment, simply loosen the black thumbscrews, position, and retighten.
Â
IMPORTANT
: A label is attached to the laser’s case and contains an arrow which indicates the
direction the laser light will shine when energized. The label must remain in place on the laser.
Removing the label voids the laser’s warranty.
Laser Operation and Safety
Turn the laser on and off using the machine setting option to turn on or off the laser lights. For more
information about turning on and off the laser, see
To turn the lasers on or off
in the
Toolbar Options
section of this manual.
Be sure the laser is attached to the machine and pointed downward toward the table before connecting
it to the port. Never point it in a direction that would project the beam into someone’s eyes. If the laser
should stop working, ensure the plug is firmly seated into the Infinity laser port.
Laser stylus port
