16 |
www.HandiQuilter.com
6. Adjust the handlebars forward or backward to
a comfortable position for quilting and tighten
the bottom screw with the 5mm hex wrench. If
using the handlebar lever, fully hand-tighten.
Â
IMPORTANT
: See To attach labels to the
handlebars in the section
Configurable
Handlebar Buttons
below.
To install the rear handlebars
ONLINE
: For more information about installing the rear handlebars, watch the video
Installing the
Rear Handlebars
at:
http://www.handiquilter.com/videos/hq-infinity/211/
.
1. Locate the four 4mm hex screws for the rear handlebars and the 4mm hex wrench.
2. Align the four holes in the handlebars with the
holes on the back of the machine.
3. Slide the bolts into holes until they stop. Use
the 4mm hex wrench to firmly tighten the bolts
and securely fasten the handles to the back of
the machine.
4. Connect one end of the RJ45, or network style,
phone cord into the handlebars and the other
end into the machine’s back panel.
Â
IMPORTANT
: See
To attach labels to the handlebars
in the
Configurable handlebar buttons
topic below.
NOTE
: After installing and plugging in the handlebars and the touch-screen displays, plug in the
power cord and test them by turning on the machine using the rear on/off switch and then the on/
off button on the left side of the machine. If nothing appears on the touch screen, check that the
handlebar cables are plugged in securely, that your machine is turned on, and that the power cord
is plugged into the machine as well as into a power source. If everything is working, turn off and
unplug the machine and continue the installation.
