HQ Infinity User Manual
| 13
Installation and Setup
Carriage
You should have already set up the Gallery Frame. Refer to the Gallery Frame manual for detailed
instructions about setting up the frame.
ONLINE
: For more information about setting up the frame, watch the video
Setting Up the Frame
at:
http://www.handiquilter.com/videos/hq-infinity/209/
.
To install the carriage and machine on the frame
1. Place the carriage on the table rails, ensuring
that the stitch regulator faces the back of the
frame.
2. Place the machine on the carriage.
U
CAUTION
: The HQ Infinity is heavy. Never
attempt to lift it alone. Always use two
people when lifting. Always lift from
the throat of the machine, not from the
handlebars or needle bar.
3. Plug the ribbon cable from the stitch regulator
connector at the back of the machine into the
stitch regulator on the carriage.
Â
IMPORTANT
: If you ever need to remove the machine from the carriage, disconnect the ribbon
cable from the stitch regulator. Failure to unplug the cable when removing the machine from the
carriage could result in damage to the cable, encoders, and carriage.
Power Cord
To install the power cord
• Insert the cord into the power connector on the rear of the machine. Plug the three-prong end into
power source. Do not turn on the machine until the handlebars and display are installed.
