20V 6-1/2" CIRCULAR SAW 23
TROUBLESHOOTING
Suspected malfunctions are often due to causes that the users can fix themselves.
Therefore, check the product using this section. In most cases the problem can be solved
quickly.
WARNING:
Only perform the steps described within these instructions! All further
inspection, maintenance and repair work must be performed by an authorised service
centre or a similarly qualified specialist if you cannot solve the problem yourself!
PROBLEM
POSSIBLE CAUSE
SOLUTION
Product does not
start.
Battery pack is depleted.
Charge the battery.
Battery pack is not installed
properly.
Confirm battery is locked
and secured to the tool.
Burned out switch.
Have the tool serviced by an
Authorized Service Center.
Blade does not
come up to speed.
Low battery.
Recharge the battery pack or
use a fully charged pack.
Excessive
vibration.
Blade out of balance.
Discard blade and use a
different blade.
Workpiece not clamped or
supported properly.
Clamp or support workpiece
properly according to this
manual.
The blade does not
follow a straight
line.
Blade teeth are dull.
Change to a new blade.
Foot is out of line or bent.
Have the tool serviced by an
Authorized Service Center.
Blade is bent.
Change to a new blade.
Cut binds, burns,
stalls motor when
ripping
Dull blade with improper tooth set.
Discard blade and use a
different blade.
Blade binds.
Reassemble the blade
and tighten the washers
according to this manual.
Improper workpiece support.
Clamp or support workpiece
properly according to this
manual.
Blade slipping.
Tool does not cut workpiece.
Reassemble the blade
and tighten the washers
according to this manual.
