Page 52 of 92
520008300 08/14
SmartServe™ Drink Mixers Service Manual
Removal and Replacement
Sensor Assembly (Cup Present)
The sensor assembly (cup present) is located on the frame near the motor assembly. The
sensor determines the lowest position of the motor and cup guard/shield assembly.
To remove the Sensor Assembly (Cup Present):
1. Remove the safety shield assembly as outlined in this manual.
2. Remove the top cover as outlined in this manual.
3. Remove three screws (1) from each side of the machine.
4. Lift the front panel wrap (2) from the machine.
NOTE:
Avoid overextending the wire harness attached to the interface panel on the wrap.
NOTE:
Cover front panel wrap to avoid scratches/damage from contact with side of machine.
5. Using a large wire tie (3), secure the wrap (2) to the machine using the hole in the top of
the side panel (4).
4
3
2
2
1
6. Remove six screws (5) and back cover (6) from machine.
NOTE:
Remove any wire ties as required. Note the routing of the sensor wiring being replaced.
7. Disconnect sensor connector (7) from control board (8).
5
6
5
8
7
