Page 41 of 92
520008300 08/14
SmartServe™ Drink Mixers Service Manual
Removal and Replacement
Linear Actuator Assembly
The linear actuator assembly is used to lower and raise the motor carriage during use.
To remove the linear actuator assembly:
1. Remove the safety shield assembly as outlined in this manual.
2. Remove the top cover as outlined in this manual.
3. Remove three screws (1) from each side of the machine.
4. Lift the front panel wrap (2) from the machine.
NOTE:
Avoid overextending the wire harness attached to the interface panel on the wrap.
NOTE:
Cover front panel wrap to avoid scratches/damage from contact with side of machine.
5. Using a large wire tie (3), secure the wrap (2) to the machine using the hole in the top of
the side panel (4).
4
3
2
2
1
6. Remove six screws (5) and back cover (6) from machine.
NOTE:
Remove any wire ties as required.
7. Remove four nuts (7) and lockwashers (8) from control board (9).
8. Position the control board (9) to the left to access and disconnect the linear motor
connector (10).
5
6
5
8
7
9
9
10
