45
Operation
Wet scrubbing (basic cleaning)
If you do not want to vacuum the floor
dry in the same working procedure be-
cause you want the solution to soak into
the dirt, for example, activate this pro-
gram.
Wet floors are a potential risk
for slipping! Ensure to provide
the corresponding information
and warning signs.
• Press the “Button for rotary
brush drive” button (Fig. 15/
9) on the left-hand operat-
ing panel.
Various functions can be switched on or
off with the following buttons according
to the conditions at the location of use:
• Reduce solution quantity (Fig. 22/1)
• Increase solution quantity (Fig. 22/3)
• Solution on/off (Fig. 22/2)
• Increase brush pressure (Fig. 22/4)
Vacuuming dry
• Press the “Button for
squeegee and suction tur-
bine” on the left-hand oper-
ating panel.
Check whether the floor is suf-
ficiently dry at regular intervals,
otherwise people could slip. If
the floor is excessively wet,
check the vehicle for leaks and
that the sealing strips are in a
good condition. If the sealing
strips are damaged, change
them; refer to Section 5.8.4.
Vacuuming with the hand-held
suction hose
The hand-held suction hose is an op-
tional accessory.
Vacuuming with the hand-held suction
hose only works when the operator is
not seated on the driver's seat (seat
contact switch is not actuated).
Always apply the parking brake
before getting out of the vehi-
cle!
• Press the “Button for
squeegee and suction tur-
bine” on the left-hand oper-
ating panel.
The squeegee remains raised.
Useful tips for cleaning
• Sweep the floor before starting wet
cleaning. This not only improves the
cleaning effect but also reduces the
vehicle‘s liability to wear.
• The floor should be treated twice in
the case of particularly dirty floors or
to remove wax (basic cleaning).
- During the first cleaning process,
the floor is scrubbed with a clean-
ing agent dosage appropriate to the
degree of soiling, whereby the
squeegee is raised.
- Let the cleaning solution work into
the floor for 5 to 10 minutes accord-
ing to the manufacturer's informa-
tion.
- Then scrub the floor again with the
squeegee lowered.
• Observe the correct dosage of the
cleaning agent. Information on dos-
age is provided on the cleaning
agent container.
• Use the manufacturer's information
