16
Starting Up
2.3
Prior to starting up for the
first time
The following work must be completed
before starting the vehicle up for the
first time:
2.3.1
Installing the rotary brushes
Two rotary brushes must be fitted in the
rotary brush head. These rotary brus-
hes are not part of the scope of delivery
supplied with the vehicle. Choose the
rotary brushes separately according to
the task to be completed (refer to Sec-
tion 4). If you ordered the rotary brus-
hes together with the vehicle, the rotary
brushes are normally already installed
by the authorized Hako dealer prior to
delivery.
Check whether rotary brushes
are fitted.
If no rotary brushes are installed, pro-
ceed as follows to install them.
The following applies to all
work on the rotary brushes:
Turn the key switch to position
0, remove the key and apply
the parking brake (Fig. 14/8).
The front rotary brush is
changed from the right-hand
side of the vehicle, the rear ro-
tary brush from the left-hand
side of the vehicle.
Fig. 4
1 Deflector
2 Deflector lock
3 Grip
1. Open the deflector (Fig. 4/1):
take hold of the grip (Fig. 4/3), raise
the deflector (Fig. 4/1), pivot open to-
wards the front and set it down (ser-
vice position).
Fig. 5
1 Locking lever
2 Brush holder
3 Rotary brush
2. Slide the locking lever (Fig. 5/1) for
the brush holder (Fig. 5/2) to the
middle of the device and hold it the-
re.
3. Allow the brush holder (Fig. 5/2) to
lower down and remove it.
4. Release the locking lever (Fig. 5/1).
5. If necessary, remove the existing ro-
tary brush (Fig. 5/13) from the
housing (Fig. 6/1).
1
2
3
1
2
3
