HAI OMNI IIe, Installation Manual, Page: 50 / 74

Page 44
The various alarm codes are sent when the indicated alarm zone is tripped. Each alarm code must be two digits long for 4/2
format (01-FF), 1 digit for 3/1 format (1-F).
To disable the digital communicator for a specific zone, set the alarm code to 0 or 00. The digital dialer will not report when this
zone is tripped.
ZONE 1 ALARM CODE: 01
0-FF
THROUGH
USER 16 CLOSE CODE: 76
0-FF
↑
SETUP AREAS
To configure the system for multiple areas, from the Installer Setup menu, press the 4 (AREA) key. The number of areas must be
specified. Also, consoles, zones, units, thermostats, and buttons must be assigned to areas. By default, one area is configured.
The display prompts for the number of areas that will be used:
NUMBER OF AREAS: 1
1-2
If you choose 2, the Setup Areas menu is displayed:
SETUP AREAS
1=CTRL 2=ZONES 3=BTTN
↓
4=CONS 5=TEMP 8=MSG
↑
SETUP AREAS: CONTROL
To assign control units to specific areas, from the Setup Areas menu, press the 1 (CTRL) key.
Units can be setup so that they can be activated from specific areas or from all areas.
Units for an entire X-10 House Code can be assigned to specific areas. Units 65-72 (voltage outputs) may be assigned
individually to specified areas. Units 73-128 (flags) can be assigned to specific areas in groups of eight.
UNITS 1-16 AREAS:
1 2 0=CLR
↓
UNITS 17-32 AREAS:
1 2 0=CLR
UNITS 33-48 AREAS:
1 2 0=CLR
UNITS 49-64 AREAS:
1 2 0=CLR
UNITS 65 AREAS:
1 2 0=CLR
UNITS 66 AREAS:
1 2 0=CLR
UNITS 67 AREAS:
1 2 0=CLR
UNITS 68 AREAS:
1 2 0=CLR