Habasit Italiana S.p.A.
Vittorio Veneto 31029 (TV)
Tel.: ++39(0)438.9113
Fax. ++39(0)438.200545
Use Manual
Hot Press PM-1056/160
Author:
A.T.
OPERATION
Edition:
09/2004
Page
D-11
Replaces:
Hot Press type PM-1056/160
SECTION D.5
PRESS OPERATION
Section. D.5.1
F
IXED AND MOBILE OPERATION WORKING
Fixed operation
Where the press is permanently positioned with available supplies of electricity, compressed
air and water. For its operation the press is managed by the following:
A regulating unit PMR-XX, which guides the temperature raising stage, and the water-air
control unit PMC-XX
A control unit PMC-XX, which guides the water circulation in the cooling system and
subsequently empties the circuit as well as inflating and deflating the presser cushion (upper
and lower).
Mobile operation
Where the press is not permanently positioned and is outside its normal working site.
To be able to work without the normal equipment available, the press requires:
A regulating unit PMR-XX that guides the rise in temperature.
The availability of running water or a tank with immersion pump working in manual mode.
A portable manual mode air compressor.
Section. D.5.2
W
ORKING CYCLES
The press's working cycles are as follows.
This manual describes the press only. For the use of the regulating unit (PMR-XX) and the
control unit (PMC-XX) see their own manuals.
Section. D.5.3
F
IXED OPERATION USE
Check the working procedures for the belt/strap, checking guidelines 3210, 3220, 3225 or the
individual technical sheet for the product.
Free the two fastening rods (4), turn them downwards and raise the upper part of the press
(1). When opening out the rods make sure you do not bring them down heavily on the floor or
supporting surface
Position the belt as required on the steel heat stabilizer (8) and fasten it, making sure it is flat.
Summary of Contents for PM-1056/160
Page 2: ......
