Habasit Italiana S.p.A.
Vittorio Veneto 31029 (TV)
Tel.: ++39(0)438.9113
Fax. ++39(0)438.200545
Use Manual
Hot Press PM-1056/160
Author:
A.T.
REGULATIONS AND GENERAL WARNING NOTES
Edition:
09/2004
Page
A-10
Replaces:
Hot Press type PM-1056/160
SECTION A.6
SAFETY WARNINGS
When using industrial machines and systems, one should be aware that moving mechanical
parts (linear or rotary movement), high voltage electrical parts, and any parts at high
temperature, etc, can cause serious damage to people and things.
In designing and building the machine, the Manufacturer focused special attention on safety
in order to supply a SAFE machine and, therefore, the Manufacturer has provided protective
and safety devices considered necessary according to the Risk Analysis carried out by
expert personnel. People in charge of system safety must make sure that the following
essential safety regulations are observed:
Do not run the machine with the fixed and mobile protective devices dismantled or
disabled.
Do not run the machine with the fixed and mobile protective devices dismantled or
disabled.
It is forbidden to switch off safety devices installed on the machine or create by-
pass systems to limit switches or micro-switches.
Operations with reduced safety devices must be carried out while observing to the
letter the instructions in the relevant descriptions, and must be performed by
specialized technicians aware of the risk, under the direct supervision of the
company person responsible for safety; active protective devices must be
restored as soon as possible, limiting this high-risk status to the minimum.
Cleaning and maintenance operations must be performed with the electrical and
pneumatic cutout devices switched OFF. To this end, the machine is provided
with emergency push-buttons which shut down the system. It is good practice to
use them as safety lockouts to avoid accidental starting during inspections or
mechanical jobs.
Clean the machine covers and the control panel with soft, dry cloths lightly
dampened in detergent; do not use solvents as they could damage the surfaces.
Do not modify the machine or its parts; otherwise, the Manufacturer shall not hold
itself responsible for damage to persons and things. Request any
modifications/customizing directly from the Manufacturer
OFF
Summary of Contents for PM-1056/160
Page 2: ......
