H3C WX6103, Installation Manual

Page: 45 / 90

37
•
Turn on the power source.
•
Turn on the power switch of the access controller.
Checks after powering on the access controller (recommended)
After powering on the access controller, check that:
•
The cooling system works normally. You should be able to hear the fans working and feel air
flowing from the air exhaust.
•
The LEDs on the switch interface board panel work normally.
Table 24 describes the status of the LEDs on the switch interface board upon access controller power-on.
Table 24 Switch interface board LED status upon access controller power-on
Step LED status
1 The four optical combo port LEDs (yellow) become steady on.
2 The optical combo LEDs go off.
3 The 10GE interface module LED (green) becomes steady on (with an interface module in place).
4
All the LEDs go into normal indication status.
For more information, see the chapter “Access controller overview.”
•
The system LEDs on the main control board panel work normally.
Table 25 describes the status of the LEDs on the main control board upon access controller power-on.
Table 25 Description of main control board LED status upon access controller power-on
Step LED status
1 All the LEDs on the front panel blink once.
2
All the LEDs go into normal indication status.
For more information, see the chapter “Access controller overview.”
Boot process
During the access controller power-on process, the console terminal connected with the access controller
displays the following information:
NOTE:
The following output may vary with main control board models and software versions. The
EWPX1WCMB0 is used as an example unless otherwise specified.
System start booting...
Booting Normal Extend BootWare....