H3C UniServer R4900 G3, User Manual

Page: 128 / 299

119
8.
Rack-mount the server. For more information, see " Rack-mounting the server ."
9.
Connect the power cord. For more information, see " Connecting the power cord ."
10.
Power on the server. For more information, see " Powering on the server ."
Verifying the installation
Log in to HDM to verify that the GPU module is operating correctly. For more information, see HDM
online help.
Replacing a GPU module with a power cord and a
GPU-dedicated chassis air baffle
The replacement procedure is the same for the GPU-V100-32G, GPU-V100, and GPU-P100
modules. This section replaces the GPU-P100.
To replace a GPU module with a power cord and a GPU-dedicated chassis air baffle:
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Replacing the access panel ."
4.
Remove the screw on the riser card that that has a GPU module attached, and remove the riser
card from the chassis, as shown in
Figure 150 .
Figure 150 Removing the riser card that has a GPU module attached
5.
Remove the GPU module. For more information, see " Replacing a GPU module without a
power cord or with a standard chassis air baffle ."
6.
Remove the screws that attach the support bracket to the GPU module, and remove the
support bracket, as shown in
Figure 151 .