H3C UniServer R4900 G3, User Manual

Page: 91 / 299

82
Figure 101 Installing the SFF diagnostic panel
c.
Connect the other end of the diagnostic panel cable to the diagnostic panel connector on
the system board. For more information, see "
Connecting the diagnostic panel cable ."
9.
Install the removed security bezel. For more information, see " Installing the security bezel ."
10.
Install the removed fan cage. For more information, see " Installing fans ."
11.
Install the removed chassis air baffle. For more information, see " Installing air baffles ."
12.
Install the access panel. For more information, see " Replacing the access panel ."
13.
Rack-mount the server. For more information, see " Rack-mounting the server ."
14.
Connect the power cord. For more information, see " Connecting the power cord ."
15.
Power on the server. For more information, see " Powering on the server ."
Installing the SD-LFF-G3-A LFF diagnostic panel
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Replacing the access panel ."
4.
Remove the chassis air baffle. For more information, see " Removing air baffles ."
5.
Remove the fan cage. For more information, see " Replacing the fan cage ."
6.
Remove the security bezel, if any. For more information, see " Replacing the security bezel ."
7.
Remove the blank or drive from the slot in which the diagnostic panel will be installed, as
follows:
{
For the 8LFF server, remove the blank from the slot. As shown in Figure 102 , insert a
tweezer into ventilation holes on the blank to prize up the clips at both sides in the blank.
Then push the blank out of the chassis from the inside of the chassis.