H3C UniServer R4900 G3, User Manual

Page: 129 / 299

120
Figure 151 Removing the GPU module support bracket
7.
Install a new GPU module. For more information, see " Installing GPU modules ."
8.
Install the access panel. For more information, see " Replacing the access panel ."
9.
Rack-mount the server. For more information, see " Rack-mounting the server ."
10.
Connect the power cord. For more information, see " Connecting the power cord ."
11.
Power on the server. For more information, see " Powering on the server ."
Verifying the installation
Log in to HDM to verify that the GPU module is operating correctly. For more information, see HDM
online help.
Replacing an Ethernet adapter
Replacing an mLOM Ethernet adapter
Procedure
1.
Power off the server. For more information, see " Powering off the server ."
2.
Disconnect cables from the Ethernet adapter.
3.
Loosen the captive screws and then pull the Ethernet adapter out of the slot, as shown in Figure
152 .
Some mLOM Ethernet adapters have only one captive screw. This example uses an Ethernet
adapter with two screws.