H3C MSR 20-20, Command Reference Manual

Page: 2458 / 2742

2458 C
HAPTER
164: U
SER
I
NTERFACE
C
ONFIGURATION
C
OMMANDS
<Sysname> ping -c 20 192.168.1.49
PING 192.168.1.49: 56 data bytes, press a to break
Reply from 192.168.1.49: bytes=56 Sequence=1 ttl=255 time=3 ms
Reply from 192.168.1.49: bytes=56 Sequence=2 ttl=255 time=3 ms
# Enter <a>, if the task terminates immediately and the system retur
ns to the current view, the configuration is correct.
--- 192.168.1.49 ping statistics ---
2 packet(s) transmitted
2 packet(s) received
0.00% packet loss
round-trip min/avg/max = 3/3/3 ms
<Sysname>
flow-control
Syntax
flow-control { { hardware [ flow-control-type1 ] | software [ flow-control-type2 ] } * |
none }
undo flow-control
View User interface view
Parameters hardware : Specifies to perform hardware flow control.
software : Specifies to perform software flow control.
none : Specifies not to perform flow control.
flow-control-type1, flow-control-type2 : Sets active or passive flow control. It takes
the value of in or out . in indicates passive flow control, meaning flow on the local
device is controlled by the remote device; out indicates active flow control,
meaning the local device controls flow on the remote device. flow-control-type1
and flow-control-type2 are mutually exclusive. For example, if flow-control-type1
takes the value of in , flow-control-type2 can only take the value of out .
Description Use the
flow-control
command to configure flow control mode.
Use the
undo flow-control
command to restore the default.
The default settings of this command vary with devices.
Note that:
■
Support for the complete flow control function varies with devices.
■
The device not supporting complete flow control does not support the
flow-control-type1 and flow-control-type2 arguments. After this command is
configured, the flow control modes for the active and passive flow control are
the same.
■
The device supporting complete flow control supports the flow-control-type1
and flow-control-type2 arguments. If neither of these two arguments are
specified, the active flow control and passive flow control adopt the same