Installation Manual
H3C S5600 Series Ethernet Switches
Chapter 3 Installing the Switch
3-19
II. Removing
Step 1: Wear an ESD wrist strip which is well grounded.
Step 2: Use the Phillips screwdriver to unscrew the captive screws at both sides of the
module.
Step 3: Pull the module towards you until it is completely apart from the chassis bottom.
Caution:
When installing/removing an optional interface module, note that:
z
Do not exert excessive strength on the module or touch the components on the
module surface.
z
Install a blank filler panel, if you do not want to install a new module right after the old
one is removed, to keep the dust out and ensure the normal ventilation of the switch.
3.8 Verifying Installation
z
The correct power source is used.
z
The ground wire is securely connected.
z
Both of the console cable and power cord are correctly connected.
z
All the interface cables are routed indoors. If there are cables outdoors, check that
the socket strip with lightning protection and lightning arresters for network ports
have been correctly connected.
