Installation Manual
H3C S5600 Series Ethernet Switches
Chapter 3 Installing the Switch
3-10
3.3 Installing/Removing the Power Module
Caution:
To avoid bodily injury, do not touch any bare conducting wire, screw, and the part which
is labeled danger voltage.
3.3.1 Installing the Power Module
The power module of the S5600 series is swappable. Follow those steps to install the
power module:
Step 1: Wear an ESD wrist strip, and make sure it is well grounded.
Step 2: Verify that the power module is not installed upside-down (the module should be
installed according to the letters. If the module is installed upside down, it will fail to be
fully seated due to the specially designed inside structure of the chassis). Use one
hand to hold the handle on the front, and another to hold the bottom. Slide it gently
along the power slot. Push the module until it is fully seated.
Step 3: Use a Phillips screwdriver to fasten the captive screws at both sides of the
module.
3.3.2 Removing the Power Module
The power module of S5600 series Ethernet switch is swappable. Follow those steps to
remove the power module:
Step 1: Wear an ESD wrist strip, and make sure it is well grounded.
Step 2: Disconnect all power of the switch.
Step 3: Use a Phillips screwdriver to unscrew the captive screws at both sides of the
module
Step 4: Use one hand to hold the handle on the front, and another to hold the top. Pull
out the module stably towards you along the power slot until it is completely apart from
the chassis bottom.
