42
[DeviceA-Bridge-Aggregation1] port trunk permit vlan 10 20
[DeviceA-Bridge-Aggregation1] quit
2.
Configure Device B in the same way Device A is configured. (Details not shown.)
Verifying the configuration
# Display detailed information about all aggregation groups on Device A.
[DeviceA] display link-aggregation verbose
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected, U -- Unselected, I -- Individual
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Aggregate Interface: Bridge-Aggregation1
Aggregation Mode: Static
Loadsharing Type: Shar
Port Status Priority Oper-Key
--------------------------------------------------------------------------------
GE1/0/1 S 32768 1
GE1/0/2 S 32768 1
GE1/0/3 S 32768 1
The output shows that link aggregation group 1 is a Layer 2 static aggregation group that contains
three Selected ports.
Layer 2 dynamic aggregation configuration example
Network requirements
On the network shown in
, perform the following tasks:
•
Configure a Layer 2 dynamic aggregation group on both Device A and Device B.
•
Enable VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other
end.
•
Enable VLAN 20 at one end of the aggregate link to communicate with VLAN 20 at the other
end.
Figure 10 Network diagram
Summary of Contents for H3C S7500E-X
Page 70: ...57 ...
