31
Step
Command
Remarks
6.
Assign an interface to the
specified Layer 2
aggregation group.
a.
Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
b.
Assign the interface to
the specified Layer 2
aggregation group:
port link-aggregation
group number
Repeat these two substeps to
assign more Layer 2 Ethernet
interfaces to the aggregation
group.
7.
Set the LACP operating
mode on the interface.
•
Set the LACP operating
mode to passive:
lacp mode passive
•
Set the LACP operating
mode to active:
undo lacp mode
By default, LACP is operating in
active mode.
8.
Set the port priority for the
interface.
link-aggregation port-priority
port-priority
The default setting is 32768.
9.
Set the short LACP timeout
interval (3 seconds) on the
interface.
lacp period short
By default, the long LACP timeout
interval (90 seconds) is adopted
by the interface.
To avoid traffic interruption during
an ISSU, do not set the short
LACP timeout interval before
performing the ISSU. For more
information about ISSU, see
Fundamentals Configuration
Guide
.
Configuring a Layer 3 dynamic aggregation group
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Set the system LACP
priority.
lacp
system-priority
system-priority
By default, the system LACP
priority is 32768.
Changing the system LACP
priority might affect the
aggregation states of the ports in
the dynamic aggregation group.
3.
Create a Layer 3 aggregate
interface and enter Layer 3
aggregate interface view.
interface route-aggregation
interface-number
When you create a Layer 3
aggregate interface, the system
automatically creates a Layer 3
static aggregation group
numbered the same.
4.
Configure the aggregation
group to operate in dynamic
mode.
link-aggregation mode
dynamic
By default, an aggregation group
operates in static mode.
5.
Exit to system view.
quit
N/A
Summary of Contents for H3C S7500E-X
Page 70: ...57 ...
